Air Sampling Filters and Devices
Air Sampling Filters and Devices
Cytiva Whatman™ EPM 2000 Air Sampling Filters
Used in high-volume PM-10 sampling equipment. Whatman™ EPM 2000 Air Sampling Filters are manufactured from 100% pure borosilicate glass. They enable detailed chemical analysis of trace pollutants with minimal interference.

Cytiva Whatman™ Quartz Air Sampling Filters, Grade QM-A, Circle
Used in many air sampling filter applications, including sampling of acidic gases, stacks, flues, and aerosols. Whatman™ Quartz Air Sampling Filters are sequentially numbered according to U.S. Environmental Protection Agency (EPA) standards and are suitable for most applications.

MilliporeSigma™ Aerosol Analysis Monitors, 37 mm
Millipore's 37 mm Aerosol Analysis Monitors are transparent, disposable, plastic filter holders for use with Type MF (mixed cellulose esters) Millipore filters. A thin cellulose support seals the filter between monitor sections to distribute sample flow evenly over the filter surface.
Sartorius Accessories for the MD8 Airscan™ Air Sampler
Accessories for use with the MD8 Airscan™ Air Sampler. The MD8 is used for quantitative detection of airborne organisms, mainly in sterile areas of Class A/B cleanrooms, isolators, or blow-fill-seal machines.
Promotions are available
MilliporeSigma™ Supelco™ ORBO™ 353 HBr on Petroleum Charcoal (20/40), 100/50 mg
Solvent desorption tube designed for gas and vapor sampling.
MilliporeSigma™ Supelco™ LpDNPH S10 Cartridge, Bed wt. 350 mg
Easy to use in the field and laboratory
MilliporeSigma™ Supelco™ ORBO™ 80 Isocyanate Filter, No Cassettes
Used for gas and vapor sampling
MilliporeSigma™ Supelco™ ORBO™ 24 2-HMP on Amberlite XAD-2 (20/40), 150/75 mg W,W,W separators
Used for gas and vapor sampling
MilliporeSigma™ Supelco™ ORBO™ 1000 Precleaned Small PUF Plug, Replacement
Used for gas and vapor sampling
MilliporeSigma™ Supelco™ Tenax™ TA/Carboxen 1018 Glass TD Tube
Preconditioned, Sealed with (Swagelok End-Fittings)
MilliporeSigma™ Supelco™ ATIS Purge and Trap/Humidifier Module
Use to generate a dynamic humidified stream of carrier gas for spiking calibration standards
MilliporeSigma™ Supelco™ LpDNPH H Series Cartridges H300, Bed wt. 10 g
Used for the sampling of carbonyls in ambient, indoor, workplace, and source atmospheres.
MilliporeSigma™ Supelco™ LpDNPH S10L Cartridge
Meets EPA TO-11A requirements.
MilliporeSigma™ Supelco™ ASSET&Trade; EZ4-NCO Dry Sampler
ASSET EZ4-NCO dry sampler kit contains 2 ASSET EZ4-NCO cartridges, 2 tubing adapters, and 1 calibration fitting. The kit makes it easy to get started sampling with ASSET - 1 cartridge for sampling and the other as a field blank.
MilliporeSigma™ Supelco™ LpDNPH Rezorian Cartridge, Bed wt. 350 mg
Solvent-compatible due to its polypropylene components and polyethylene frits
MilliporeSigma™ Supelco™ LpDNPH Ozone Scrubber Rezorian Cartridge, Potassium Iodide (KI)
Ozone scrubbers are recommended for sampling carbonyls in high humidity environments.
MilliporeSigma™ Supelco™ ORBO™ 1000 Precleaned Small PUF Cartridge
Used for gas and vapor sampling
MilliporeSigma™ Supelco™ ATIS Extraction Glassware with Micro Connector
Use the ATIS to thermally extract samples onto an adsorbent tube.
MilliporeSigma™ Supelco™ ORBO™ 52 Large Activated Silica Gel (45/60) 150/150 mg W,W,W separators
Used for gas and vapor sampling
MilliporeSigma™ Supelco™ Male Luer Fitting for 1/8 in. Tubing
Male Luer Fitting for 1/8 in. Tubing is an accessory for use with TDS3 Thermal Desorption Storage Containers.