Labconco™ CApture™ Portable Fuming System

Quickly fixes latent fingerprints at a crime scene using microburst or traditional CA fuming methods, while protecting the user from hazardous fumes

Supplier:  Labconco™ 3420022

Catalog No. 09-682-772

Description

Unique design combines all the components needed in one compact system: a heater to heat the Super Glue™; a shatter-resistant, clear protective chamber to contain the fumes as they react with latent prints; an exhaust blower; and particulate/carbon exhaust filter. No ducting is required. Since prints may be easily developed at the scene, irrelevant evidence may be ruled out thus saving lab processing time and storage space.

• Epoxy-coated steel housing with clear, shatter-resistant chamber
• Leveling foot with locking pin stabilizes developer in upright position
• Inverter ready, low energy usage (75w) allows system to run on car battery when connected to user-supplied inverter
• Three-way heater/off/vent switch activates heater during print development and activates vent after prints have been fixed
• Particulate/activated carbon filter cartridge traps smoke and CA fumes exhausted from chamber; cartridge has capacity for 100 cycles
• Microprocessor-controlled heater allows user to set temperature in one-degree increments from 120° to 350°F (50° to 177°C)
• Once set, temperature of heater stabilizes at set point (±15° F) within 3 to 5 minutes
• Built-in blower pulls air from chamber, through filter and exhausts it back into room
• Accessory Exhaust Connection Kit allows air to be exhausted out window or into fume hood
• Instructions by video (available online) for setup and use

Compliance

CE conformity marking.

Specifications

• Dimensions (D x W x H): 8 x 8 x 16 in. (20 x 20 x 41 cm)
• Height (Metric): 48.26 cm
• Width (Metric): 39.37 cm

• Height (English): 19 in.
• Width (English): 15.5 in.

Safety and Handling

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov